Specific Steps For Towing With A Winch

1. Check the drum first. Before starting, make sure the noose is neatly wound around the drum.
2. If the noose comes out, it should be prevented from swinging back and forth. If the noose snaps, the swinging rope can be very dangerous. However, it can be avoided by simply placing a pad on the taut noose.
3. Start towing. If you are pulling your own car with a noose, and you are driving in the car, it is best to have someone outside the car to help you. The driver can operate the winch on the car according to the instructions of the commander outside the car.
4. If the noose is twisted together, be sure to pull it apart. The noose can easily cross or become uneven on one side as it is wound onto the drum. Therefore, keep an eye on its status.
5. When the car can walk freely, the dragging is completed. Once back on level ground, check the condition of the vehicle and lines. If the car can be driven without external force, the process of towing with a winch is over.
6. Roll up the noose. Tighten the noose and send it back carefully. If the noose crosses or twists on the drum, unwind it completely before recoiling it.
7. Finally put the hook. When the noose is down to the last bit, tie the hook to the side of the winch. Then wind up the little bit of noose that is left, and hold down the hook.
8. Remove the remote control.